Troubleshooting - Hamilton Beach 54614 Manual De Instrucciones

Ocultar thumbs Ver también para 54614:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Optional Cleaning
1. Remove dispenser assembly cap
2. Wash dispenser and parts in hot,
soapy water. Rinse and dry
thoroughly. Do not soak.
NOTE: Do not remove seal rings
from adaptor.

Troubleshooting

PROBLEM
Blender leaks.
Ice not crushed.
Does not
blend well.
Does not dispense.
Dispenser leaks.
Cannot remove
cutting assembly.
840155505 ENv01.indd 7
840155505 ENv01.indd 7
3. Reassemble plunger inside of
by rotating
dispenser body and rotate cap
counter-
clockwise until tight.
clockwise.
Dispenser
Assembly
Cap
Plunger
Dispenser
Assembly
Body
PROBABLE CAUSE
• Tighten cutting assembly on jar.
• Make sure gasket is in place on cutting assembly.
• Make sure gasket is not damaged. If damaged, please
call our toll-free customer service number to order a
replacement.
• Make sure lid with filler cap is pushed down tightly
on jar.
• See ice crushing instructions in "Blending Specific
Foods" section.
• Make sure enough liquid has been added. A
minimum of 10 ounces (300 ml) is recommended.
• Make sure blender is ON.
• Make sure seal rings are in place on dispenser
adapter.
• Tighten dispenser cap (located above dispenser body).
• Loosen collar by holding jar and turning cutting
assembly counterclockwise.
Adaptor
Seal Rings
7
7/19/12 1:13 PM
7/19/12 1:13 PM

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

54615b5461954615

Tabla de contenido