INTRODUCTION
Proper Use
Any use other than that described or any modification of
the product is not permissible and may result in injury
and/or damage to the product. The manufacturer is not
liable for damage caused by improper use. The product is
not intended for commercial use.
Description of parts and features
A
Pole
Tent
2 PCS
1 PC
D
Peg
Carry Bag
8 PCS
1 PC
Tent Dimensions:
Outer tent: 110cm x 110cm x 190cm
Pitching dimension: 120cm x 120cm
WARNING
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
Keep all flames and heat sources away from this tent
fabric. We recommend that you always position your tent
upwind from a camp fire. This will reduce the chances of
having embers land on your tent. In case of fire, please
find the exit to escape from the fire.
Never set up the tent near the river, under the tree of
other objective hazards.
Keep exits clear.
Make sure ventilation openings are open all the time to
avoid suffocation.
SAVE THESE INSTRUCTIONS
WARNING: Poles contain fiber glass. We strongly
recommend wearing gloves during assembly to avoid
irritating hands.
Owner's Manual
Model No.#68002
Station Port
B
C
Guy rope
4 PCS
E
ASSEMBLY
Setting up the tent
B
A
FIG1
1. Lay the tent <A> on the
ground. Pull the four
corners outwards.
Note: Make sure that the
channels for the poles<B>
are facing upwards.
Note: Make sure that the
zip on the entrance to the
tent is closed.
2. Push the poles <B> completely into the channels.
(FIG1)
3. Stand the tent <A> up and push the ends of the poles
<B> into the iron bars (which are on the each corner of
the tent <A>. (FIG2)
4. Fasten the roof of the tent <A> onto the pole junction
with the sewn-on tie. (FIG2)
5. Secure the tent by pushing the tent pegs <D> into the
ground loops. (FIG2)
6. Tie one end of the guy ropes <C>onto the four corner
hoops of outer tent <A>. (FIG3)
7. Tie the other end onto the tent pegs <D> and fasten
them by inserting the tent pegs <D> into ground. (FIG3)
8. Note: Ensure that guy ropes <C> are about at an angle
of 45°
9. Do not pull the guy ropes <C> too tight.
DISASSEMBLE AND MAINTENANCE
Follow steps 1-9 in reverse order.
1. Clean the tent and remove any stains with sponge and
cool water. Please use non-detergent soap for serious
cleaning.
2. Never machine wash or machine dry the tent. Hand
wash and air dry.
3. Please allow all parts to dry thoroughly before you
repack the tent. This will prevent the formation from
mould, bad odours and discolouration
4. Stitch with thread to repair minor leaks, fabrics and
plastic sheets damage. Use ropes to connect broken
frame parts. Use tapes to repair the coating broken
parts.
5. Silicone spray could be use onto zippers if stick
STORAGE
Store the tent in the stuff sack and place it in a cool, dry
area out of sunlight and away from heat sources and
rodents.
2
D
FIG2
45°
FIG3
C