Klimatronic Heat Supreme 2000 Manual Del Usuario página 19

▪
▪
▪
▪
Motion sensor:
o
▪
▪
•
Towel warming function:
Regardless of whether you are in standby, manual or automatic mode, you can use the towel
o
warming function. Please make sure that the appliance is connected to the power supply. Press
the towel warming button. To exit, press the button again.
During heating, the corresponding indication light is lit continuously. The function heats at 200W
o
for a maximum of two hours and then automatically switches off.
Note: When you press the on/off button to stop heating in manual or automatic mode, the towel
o
warming function is not affected. The function is also independent from the target and ambient
temperature.
•
Display energy saving function:
Regardless of the operating mode, all lights on the display and control panel go out if no keys
o
are touched after one minute. To reactivate the lights, press any key on the control panel.
•
Regardless of the mode in which the heating function is switched off, the fan continues to operate for
15 seconds before it turns off.
Cleaning
•
Always disconnect the appliance from the power outlet and let it cool before cleaning. Never immerse
the appliance in water to prevent electric shocks.
•
Wipe over the exterior of the appliance with a soft wet cloth and then wipe dry with a dry cloth.
•
Please do not use any aggressive or chemical cleaning agents or abrasive cleaning agents such as
steel wool.
•
Please use a vacuum cleaner to remove any dust from the air inlet and outlet.
•
If you don't use the appliance for a longer period, store it in a dry, well-ventilated place away from fust.
Do not place heavy objects on top of the unit.
•
Dust filter: The appliance is equipped with a cleaning reminder for the dust filters. If the filters have been
in use for more than 150 hours or if the inner temperature of the appliance reaches its limit due to the
dirt, an alarm signal sounds. In this case, please proceed as follows:
Press „OK" to stop the alarm.
o
Turn off the appliance and remove it from the power
o
supply. When the unit has cooled down, loosen the two
ST3x10 screws on the back of the appliance with a
screwdriver. Pull out the two dust filters left and right as
shown in the figure.
Clean the dust filters directly under water. Do not use
o
caustic or abrasive material during cleaning. Let the filters
air-dry completely.
Reinsert both filters and fix them with the screws. Turn the
o
appliance on again.
slowly. Press „OK" to activate the heater during the represented time. When activated,
the box lights continously.
Please continue the settings for the other time periods by switching between the boxes
with the buttons „+" and „-". If you want to deactivate a box, select it, press „SET" and
then „OK". The box will dissappear and is deactivated.
When you have finished activating or deactivating all boxes of the selected day, the
default target temperature starts to blink. Use „+" and „-" to choose the target
temperature from 5-40°C. Please confirm with „OK".
You may now make the settings for the other days using the same steps. As soon as
all days have been processed, the appliance automatically enters the standby mode.
Press the week program setting button to start the program. The indicating light
the active boxes of the day are lit continously duing the program. To stop, press the
week program setting button again.
Note: The program is saved even after turning off. If the appliance is turned of for five
days, all settings must be made again.
The motion sensor is always automatically activated and deactivated with the week
program. Manual setting is not possible. As soon as the appliance starts to heat at the
set time, the sensor starts to scan movements within a radius of 3m.
If no movement is detected, heating is stopped after 15 min. and resumed as soon as
someone moves within the radius.
and