Worx WU505 Manual De Instrucciones página 10

ON/OFF
Light
flash
Red on
Red slow
- - - - - Dead battery
flash
Red fast
-------------
flash
Green on
Green slow
- - - - -
flash
Green fast
-------------
flash
Hot/cold battery pack delay
This charger has a hot/cold battery pack
delay feature. When the charger detects
a battery pack that is too hot or cold (the
green light will flash slowly), it automatically
starts a hot/cold pack delay, and suspends
charging until the battery pack has reached
the correct temperature.The charging process
will then automatically begin (red light on
continuously).This feature ensures maximum
10
battery life.
Leaving the battery pack in the charger
If a fully charged battery pack is left in the
charger, the green light (9) will remain on.
The battery pack will remain charging with a
current of about 150ma.
Note: a battery pack will slowly lose its
charge when kept out of the charger or left
in an unplugged charger. It may need to be
recharged before use.
Weak battery packs
This charger will detect a weak battery pack.
When a weak battery pack is inserted into the
charger, the charger will try to repair it.This
process will last about 30mins (the green light
will flash slowly). When the repair is finished,
it will automatically begin to charge the
battery pack to the highest capacity possible
(the red light stays on). If the green light (9)
flashes for more than 30mins, the red light (a)
will begin to flash slowly indicating the battery
pack is dead.
Note: repaired battery packs are still usable
but should not be expected to perform as
much work as new battery packs.
Cordless Reciprocating Saw
13L-WU505-070305¸ÄFÓïCE´¦.indd 10
All manuals and user guides at all-guides.com
Important charging notes:
Status
1. For a new battery or a battery that has been
Charging
Battery failure or
2. Longer life and better performance can
charger invalidated
Charging complete
Hot/Cold delay; weak
battery repair; battery
abnormal
Charging battery too
hot
3. Never freeze your charger or immerse
4. When the battery pack fails to produce
5. When charging it is normal that the charger
6. If the battery pack does not charge
a) Check current at power outlet by plugging
b) Plug and unplug to check whether the
c) Check whether the battery has been
d) Move the charger and battery pack to
e) If the charging problem persists, take
f) Under certain conditions, when the charger is
in storage for sometime, please recharge
the battery before use. If you want to
store the battery for a long time, please
fully charge the battery pack to ensure
maximum battery life.
be obtained if the battery pack is charged
when the air temperature is between 65
F and 75 F (18 -24 C). Do not charge the
o o o
battery pack in air temperatures below
+ 40 F (+4.5 C), or above 105
o o
This is important as it can prevent serious
damage to the battery pack.
charger in water or any other liquid.
sufficient power on jobs that were
previously done easily, please recharge you
battery, do not continue to use under this
condition.You may charge a partially used
pack whenever you desire with no adverse
affect on the battery pack.
and battery pack may become warm to
touch.
properly:
in another appliance.
charger is ok
damaged
a location where the surrounding air
temperature is approximately 65
(18 -24 C).
o o
the tool, battery pack and charger to an
authorized service center.
plugged into the power supply, the exposed
charging contacts inside the charger can be
shorted by foreign material. Foreign materials
of a conductive nature such as metallic particles
should be kept away from charger cavities.
Always unplug the charger from the power
supply when there is no battery pack in the
charger or before attempting to clean.
o
F (40.5 C).
o o
F - 75 F
o o
ENG
3/5/2007 4:43:45 PM