Machine Information - VONROC OT502AC Traducción Del Manual Original

6) Service
a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the
power tool is maintained.
b) Never service damaged battery packs. Service
of battery packs should only be performed by the
manufacturer or authorized service providers.
ADDITIONAL SAFETY WARNINGS FOR
MULTITOOLS
Contact with or inhalation of dust coming
free during use (e.g. lead-painted surfaces,
wood and metal) can endanger your health
and the health of bystanders. Always wear
appropriate protective equipment, such as
a dust mask. Always use proper dust
extraction during use.
• Do not work materials containing asbestos.
Asbestos is considered carcinogenic.
• Do not work metal with a magnesium content of
more than 80%.
• Be very careful when working painted surfaces.
• Do not use accessories which are not specif-
ically designed and recommended by the manu-
facturer. Risk of personal injury.
• Inspect the machine and the accessories before
each use. Do not use accessories which are
bent, cracked, or otherwise damaged. If the
machine or one of the accessories is dropped,
inspect the machine or the accessory for damage.
If necessary, replace the accessory.
• Only use accessories that are recommended by
the manufacturer.
• Only use accessories that are suitable for the
application.
• Only use accessories with the correct dimensions.
• Do not use accessories that require liquid cool-
ants. Risk of electric shock.
• Make sure that the accessories are properly
mounted. Do not use adapters or other aids to
mount accessories with another spindle diameter.
• Make sure that the maximum speed for the
accessory is larger than or the same as the
maximum speed of the machine. Refer to the
rating plate on the machine.
• Let the machine run at no load in a safe area
after mounting the accessories. If the machine
vibrates strongly, immediately switch off the
machine, remove the mains plug from the
WWW.VONROC.COM
mains, and try to solve the problem.
• Make sure that the workpiece is properly sup-
ported or fixed.
• Wear safety goggles. Wear hearing protection.
Wear a dust mask. If necessary, use other
protective means, such as safety gloves, safety
shoes, etc. Risk of personal injury.
• Keep bystanders away from the work area. Make
sure that all persons in the work area wear
protective equipment. Risk of personal injury.
• Keep the mains cable away from the rotating
accessory. If the mains cable touches the rotat-
ing accessory, your hands or arms may come
in contact with the accessory. Risk of personal
injury.
• Hold the machine by the insulated gripping
surfaces where the accessory may contact hid-
den wiring or the mains cable. If the accessory
contacts a 'live' wire, the exposed metal parts
of the machine can also become 'live'. Risk of
electric shock.
• Do not use the machine while carrying it at your
side. Risk of personal injury.
• Do not use the machine near flammable materi-
als. Risk of fire.
• Beware that the accessory continues to rotate
for a short period after switching off the machine.
Do not attempt to bring the accessory to a
standstill yourself.
• Never put the machine down on a table or a
workbench before it has been switched off.
• Regularly clean the ventilation slots. Risk of
electric shock.
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm . If you use a extension
2
cable reel, always fully unroll the cable.

2. MACHINE INFORMATION

Intended use
Your multitool has been designed for light sanding,
sawing and scraping applications.
EN
5