Publicidad
Idiomas disponibles
Idiomas disponibles
15. GROUP 1,2. This jacks connect with the chairman unit and delegates units. There are two
connecting channels, each channel can connect with 35 units, therefore, that is could connect up to
70 units.
16. AC power input jack. Use the closed IEC cable, plugging in an adequate AC outlet.
WMC 10D
Each delegate microphone is equipped with a loudspeaker and a cardioid backplate electret microphone.
To prevent acoustic feedback, the loudspeakers is switched OFF while the microphone is in use. A red
lamp located in the microphone indicates to other participants when the microphone is active . Up to 60
delegate units can be connected in a single system in two loop-through-wired groups of 30.
WMC 10C
The chairman unit has the same functions and appearance as a delegate units but with the addition of
a microphone over-ride button (PRIORITY). This button switches the delegate microphones to OFF.
1
2
3
4
5
1. Mic capsule. To pick up voice of the speaker and send to the system.
2. Mic light. To indicate the working condition of the microphone. Lit: Active.
3. Microphone button. To turn on/off the microphone.
4-5. Loudspeaker volume control ( + or -)
6. Loudspeaker
7. Earphone jack 3.5 mm
8. Priority. (Only in WMC 10C) Allow to chairman cut off the rest of delegate units.
OPERATING
Each CMU 100 incorporates a 2m long mains cable with IEC and earthed schucko connector. Place the
CMU 100 unit in a suitable position and connect it to an adequate AC outlet.
Connect the first microphone of the chain using the 5m included cable to the GROUP 1 or 2 output
(This first microphone can be delegate (WCM 10 D)or chairman (WCM 10 C), it is a daisy chain and the
order of the microphones does not affect to their operation).
Now connect the rest of microphones using the output connector of the previous one.
8
6
7
PAG. 3
User Manual/Manual de Instrucciones
1
2
3
4
5
6
7
CMU 100
EN
Publicidad
