SonicWALL SonicWave 432o Guía De Inicio página 9

The FCC regulations provide that changes or modifications not expressly approved by SonicWall Inc.
could void your authority to operate this equipment.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference with radio or television reception, which can be determined by
turning the equipment off and on, you are encouraged to try to correct the interference by one or more of the
following measures:
 Reorient the receiving antenna.
 Relocate the system with respect to the receiver.
 Move the system away from the receiver.
 Plug the system into a different outlet so that the system and the receiver are on different branch circuits.
If necessary, consult a representative of SonicWall Inc. or an experienced radio/television technician for additional
suggestions.
This SonicWall Wireless WLAN device must be installed and used in strict accordance with the
manufacturer's instructions as described in the user documentation that comes with the product. Any
other installation or use will violate FCC Part 15 regulations. Modifications not expressly approved by
SonicWall could void your authority to operate the equipment.
The following information is provided on the device or devices covered in this document in compliance with FCC
regulations:
 Product name:
SonicWall SonicWave 432o
Regulatory Model: APL42-0C1
 Company name: SonicWall Inc. is the responsible party for this product. For an EMC compliance issue or a
regulatory inquiry, please use the following contact information:
SonicWall Inc.
5455 Great America Parkway
Santa Clara, CA 95054 USA
408-745-9600
Radiation exposure statement (FCC)
The radiated output power of this device is below the FCC radio frequency exposure limits.
Nevertheless, this device should be used in such a manner that the potential for human contact
during normal operation is minimized. This device has been evaluated for and shown compliant
with the FCC RF Exposure limits under mobile exposure conditions (antennas are greater than 58
cm from a person's body). Details of the authorized configurations can be found at
https://fjallfoss.fcc.gov/oetcf/eas/reports/GenericSearch.cfm
the device.
United States of America authorized channels
SonicWall declares that the APL42-0C1 (FCC ID: 2AKCZ-0C1) when sold in the USA is limited to CH1-CH11 by
specified firmware controlled in the USA.
by entering the FCC ID number on
Safety and Regulatory Information
9