Special Instructions - Kalorik USK SIT 25803 Manual De Instrucciones

pulled or tripped over.
15. If the supply cord is damaged, disconnect the appliance from
the socket immediately and the supply cord must be replaced by
the manufacturer, its service agent or a similarly qualified person
in order to avoid a hazard.
16. Do not operate the appliance if it has been dropped or
damaged. To avoid the risk of electric shock, do not disassemble
the appliance, take it to a service agent or a similarly qualified
person for examination and repair. Incorrect reassembly can
cause a risk of electric shock when iron is used.
17. Do not continue to use this appliance if any part appears to be
faulty, missing or damaged.
18. Do not carry out maintenance work other than that shown in this
manual.
19. Do not put anything other than water into the reservoir.
20. The iron must be used on a stable surface.
21. When placing the iron on its stand, ensure that the surface on
which the stand is placed is stable.
22. The iron is not to be used if it has been dropped, if there are
visible signs of damage or if it is leaking.

SPECIAL INSTRUCTIONS

To avoid a circuit overload, do not operate another high
•
wattage appliance on the same circuit.
If an extension cord is absolutely necessary, a 10-ampere cord
•
should be used. Cords rated for less amperage may overheat.
Care should be taken to arrange the cord so that it cannot be
pulled or tripped over.
3
USK SIT 25803 - 080425