Sanus VXF220 Instrucciones De Montaje página 6

1-2 Select the hardware diameter and length
A
1-3
Attach spacers to brackets
A
[02]
[14, 15,
16, 17]
6
B
[02]
[23]
[14, 15,
16, 17]
Your TV type will help you determine which hardware confi guration
to use. Match your type of TV to the suggested hardware
confi guration on the next page.
A. Installation option using 4 or 7mm spacers (TVs with fl at backs)
B. Installation option using 14mm spacers (TVs with irregular backs)
C. Installation option using 24mm spacers (For TVs with irregular
backs that require more length than the 14mm spacer provides.)
Hand thread screws into the threaded inserts on the back of your TV
to determine the correct screw diameter (M4, M5, M6, or M8).
CAUTION:
damage! Verify that there are adequate threads to secure the
brackets to the monitor. If you encounter resistance, stop
immediately and contact customer service. Use the shortest screw
and spacer combination to accommodate your needs. Using
hardware that is too long may damage your TV.
B
Attach shoulder washers [23] and spacers to the brackets [02].
1. Push the shoulder washer [23] through the appropriate
openings of the brackets [02].
2. Snap shoulder washer [23] into the spacer you selected in
step 1-2.
If your TV has a fl at back, use either the 4mm or 7mm spacer
[14, 15].
If your TV has a curved or obstructed back, or if you need more
room for cables, recesses, or protrusions, use either the 14mm or
24mm spacer [16, 17].
[23]
Avoid potential personal injuries and property
C
6901-002080 <03>