Functions; Area Of Operation; Area Of Operation / Buttons - Kettler UT 688 Serie Manual De Instrucciones

Functions

The electronics features the following functions:
• Total kilometres are saved
• Default setting of training data
• Pulse display with pulse monitoring
• Fitness note following one minute of pulse recovery
(RECOVERY)
• Conversion from Kjoule to Kcal

Area of Operation

The 5 buttons are briefly explained below.
MODE
(press briefly) before the training
• Change to the next default area.
Settings or values are adopted.
MODE
(press briefly) during the training
• Switch automatic display change on or off
• Change to the next display area.
MODE
(press for longer) RESET
• Clear the display for a restart.
MODE RESET
and
at the same time
• Change between Kjoule and Kcal display in conjuncti-
on with clearing of the display.
Minus – / Plus +
With these function buttons, values are changed in the dif-
ferent input areas before the training
• Press for longer > faster value throughput
RESET
(press briefly) before the training
• Clearing of the displayed default value
RESET
(press for longer)
• Clear the display for a restart.
RECOVERY
(recovery pulse with fitness note)
With this function button, the recovery pulse function is
started and a fitness note determined.
Pulse Measurement
Your pulse can be measured using 3 sources:
1. Ear clip(optional)
2. Hand pulse sensors
3. Chest strap with plug-in receiver (optional)
UT6886/UT6887
11
GB