Changing The Presser Foot - Singer ET-1 Manual De Instrucciones

CHANGING THE PRESSER FOOT

1
2
3
4
Attention:
("O") position when carrying out any
of the operations shown below.
1
Attaching the presser foot holder
Raise the presser foot bar (a) by raising
the presser foot lifter. Attach the presser
foot holder (b) as illustrated.
Attaching the presser foot
2
Lower the presser foot holder (b) until
the cut-out (c) is directly above the pin
(d).
Raise the lever (e).
Lower the presser foot holder (b) and
the presser foot (f) will engage
automatically.
Removing the presser foot
3
Raise the presser foot.
Raise the lever (e) and the foot will
disengage.
4
Attaching the edge/guilting guide
The edge/quilting guide (g) can be
attached as illustrated. Adjust as
needed for hems, pleats, quilting, etc.
20
Turn power switch of off