Button Sewing - Singer ET-1 Manual De Instrucciones

BUTTON SEWING

1
2 2
5
6
3
4
1
Select the pattern 25 from the Group
Patterns "A" to get the button sewing stitch.
Change the presser foot to the button
sewing foot.
Move the drop feed lever to "
the feed dogs.
2
Position the work under the foot. Place the
button in the desired position, lower the foot.
3
Adjust the stitch width to " 2.5-4.5 "
according to the distance between the two
holes of the button.
4
Turn the handwheel to check that the needle
goes cleanly into the left and right holes of
the button.
5
Before sewing, press the Auto-lock button to
sew reinforcement stitches automatically at
the beginning and at the end of the stitch.
If a shank is required, place a darning
needle on top of the button and sew.
6
For buttons with 4 holes, sew through the
front two holes first, push work forward and
then sew through the back two holes.
37
" to lower