Designation Of Parts - Engel MD14F El Manual Del Propietario

SPECIFICATION
MODEL
NET VOLUME
OUTER DIMENSIONS
(W × D × H)
INPUT RATING
REFRIGERANT
WEIGHT
1 INSTALLATION
Your shockproof fridge should be installed on a level and solid surface although it will
operate satisfactory for long period on angles of up to 30° . Be sure your fridge is not in
direct sunlight, (Fig 1) near a gas stove, heater, or other heat-generating appliances.
In order to get good cooling performance and less current consumption, adequate
ventilation for refrigerator is needed. Install refrigerator away from each wall at least
150mm or more. (Fig 2)
Avoid installing your fridge close to a kitchen sink or faucet. (water)
Your fridge has been thoroughly cleaned before shipment from the factory.
It is advisable, however, to clean the interior once more before use.
Clean the interior with a cloth moistened in warm water and wipe with a dry cloth.
=CAUTION=
＊ Never use your ENGEL fridge to store gasoline or other inflammable vapors and liquids
as these may cause explosion.
＊ Do not touch evaporator and other metal parts of cabinet inside with a wet hand, as
this may cause frostbite.
＊ Do not remove or modify any of the electrical parts as this may cause electric shock or
damage your fridge.
MD14F
14L
442 × 284 × 398
DC12V 2.8A
HFC-134a
APPROX.11.5kg

DESIGNATION OF PARTS

LID
− 2 −
GREEN
POWER
LAMP
SHOLDER
STRAP
CABINET
LOUVER
CONTROL
PANEL