Installation - HAMPTON BAY 18531-000 Guía De Uso Y Cuidado

Installation

1
Preparing the unit for installation
Remove the existing trim from the housing.
Locate the "C" tabs inside the housing. (Some housings
may have "L" shaped tabs).
Position tabs toward the center of the housing.
Peel off the protective backing (1) that is preattached to the
tape on the back of the two clips (A).
3
Attaching the conversion plate
Place the conversion plate (C) against the housing so the
two open slots on the conversion plate (C) are under the
installed clips (A).
Use the appropriate size nut on the installed clips (A) for
the diameter of the housing.
Attach the conversion plate (C) to the housing with two
long screws (BB). Ensure the long screws also go through
the clips (A).
A
BB
C
2
A
1
4
5
Inserting the clip and securing the
conversion whip
Insert the two clips (A) into the the "C" or "L" tabs on the
housing.
Press the two clips (A) toward the housing so the two clips
(A) adhere to the housing wall. This will prevent the two
clips (A) from moving during installation of the conversion
plate (C).
Screw the electrical conversion whip (B) into the existing
socket.
Secure the green grounding clip (1) from the conversion
plate (C) to the housing wall using the included screw.
B
1
A
Installing the mounting bracket
Attach the mounting bracket (not included) to the
conversion plate (C) with the two short screws (AA).
Place all the electrical connections of the unit into the
housing. There should be no loose strands or connections
present.
Mount the new xture according to installation instructions
provided with the new xture.
The xtures illustrated are examples only; actual
installations may vary.
C
Please contact 1-877-527-03123 for further assistance.
C
AA
HAMPTONBAY.COM