STEINEL PROFESSIONAL IR Quattro DALI Manual De Instrucciones página 23

Functions – Settings by DIP Switch
DIP 1
Normal mode / Test mode (NORM / TEST)
Test mode has priority over all
other settings on the presence
detector and serves the purpose
of checking for proper working
order as well for testing the
detection zone. Irrespective of
DIP 2
Semi-automatic mode (MAN) / fully automatic mode (AUTO)
Semi-automatic mode: (MAN)
The light now only switches
'OFF' automatically. Light is
switched 'ON' manually. Light
must be requested using the
Fully automatic mode: (AUTO)
The light automatically switches
'ON' and 'OFF' in relation to
brightness when someone is
present. Light can be switched
'ON' and 'OFF' manually at any
time. This temporarily interrupts
DIP 3
Button/switch
Tells the sensor how to interpret
the incoming signal. Assigning
external buttons/switches allows
you to operate the detector as a
semi-automatic unit and over-
ride it manually at any time.
DIP 4
'ON'/'ON'-'OFF' button
In the 'ON'-'OFF' setting, the light
can be switched 'ON' and 'OFF'
manually at any time. In the 'ON'
DIP 5
Constant light 'ON'/'OFF'
Provides a constant level of
brightness. Detector measures
the prevailing level of daylight
and activates sufficient artificial
light to achieve the required
ambient light level, the presence
detector activates the light to
stay 'ON' for approx. 8 sec. in
response to movement in the
room (blue LED flashes when
movement is detected). All user-
button and stays 'ON' for the
time set at the potentiometer.
(pressing twice switches 'ON'
for 4 hours).
the automatic switching func-
tion. Irrespective of the settings
selected, light stays 'ON' for 4
hours after manually pressing
the button twice or switches
'OFF' after manually pressing the
■
Operation either by button
or switch
■
Several buttons possible
on one control input
■
Only use illuminated
pushbutton with neutral
conductor connected
setting, light can no longer be
switched 'OFF' manually. The
stay-'ON' time starts from the
level of brightness. As daylight
changes, the switched-in artifi-
cial lighting component is ad-
justed accordingly. In addition
to the daylight component,
- 22 -
selected potentiometer settings
apply in normal mode. The pres-
ence detector can also be set by
means of the blue LED without
any load connected.
button once. Pressing the but-
ton before the 4 hours elapse
returns the Presence Control
IR Quattro to the normal operat-
ing mode.
■
Cable length between sensor
and switch < 50 m
beginning again each time the
button is pressed.
artificial light is also switched
'ON' and 'OFF' in relation to
whether or not persons are
present.