Bard EnCor Ultra Instrucciones De Uso página 2

The E C U
®
Breast Biopsy System is delivered assembled, with the exception of the optional
N OR LTRA
Procedure Tray, which is detached and supplied and packaged separately. To attach the Procedure
Tray, carefully remove the tray from the packaging.
Unlock the rear handle from the system by pressing the release button under the system as
illustrated in Figure 6. Remove the handle and replace with the Procedure Tray stand, aligning the
legs of the tray stand into position as illustrated in Figure 7. Place the removal tray on top of the
stand.
Figure 6 – Release button to attach the Procedure Tray
Figure 7 – Insert the Procedure Tray Stand
Procedure Setup
Prior to transporting the system, unlock the system casters. When transporting the system, push
or pull using the system handle or the handle located on the optional Procedure Tray stand. To
Bard supplied packaging.
Position the E C U ®
1. N OR LTRA Breast Biopsy System as required for safe use and plug the
a. The system includes four casters with locking brakes. After the system is positioned,
lock the casters as illustrated in Figure 8.
b. Optional: The tray height may be adjusted by releasing the locking lever on the stand
and adjusting the tray up or down as illustrated in Figure 9.
Figure 8 – Locking the system casters
Figure 9 – Adjusting the tray height
Connect the E C
2. ® Breast Biopsy Driver to the rectangular connector on the side of the
N OR
console illustrated in Figure 10. Reference the applicable Driver Instructions for Use for further
information of Driver setup. If desired, connect the appropriate Foot Pedal to the connector on
the rear of the console as illustrated in Figure 11.
Figure 10 – Install the E C
®
N OR Driver to
the rectangular connector on the
side of the console
Figure 12 – Turn on the E th E C
12 T
Power Switch located on the display panel
3. Turn the system on via the Power Switch on the display panel as illustrated in Figure 12.
4. Install the Vacuum Tubing by loading the T-connection, then threading through the vent
control and vacuum control as illustrated in Figure 13. Install the Vacuum Canister by
placing the Canister in the designated location. Attach the system tubing to the VACUUM
port and the disposable E C
N OR
the vacuum components, the system door may be closed to conceal the components during
the biopsy procedure.
Figure 13 – Installing the Vacuum Tubing and Canister
Figure 14 – The E C U
®
N OR LTRA
the biopsy to conceal the vacuum components
2
Figure 11 – Optional: Install the E
Foot Pedal to the round connector
on the rear of the console
C U U
N OR LTRA ® ® ® B Breast Biopsy System using the t Bi S t
U
®
Vacuum Tubing to the PATIENT port. After installing
LTRA
Breast Biopsy System door may be closed during
C
®
N OR
i