Connect Power; Leveling - GE PCR06BATSS Manual Del Propietário

LEVEL
3
• Use an adjustable wrench to turn the leveling legs and
raise or lower the product.
• Adjust carefully; the product should be level and plumb
with cabinetry, and should align with adjacent toekick
height.
Turn Right to Lower
Turn Left to Raise
If you skipped Step 2:
• Select the hinge cover marked "R" or "L", depending on
door swing.
• Peel backing off the tape inside the decorative hinge
cover. Press and snap into position.
Installation Instructions
12

CONNECT POWER

4
• Connect power cord plug to a properly grounded
receptacle.
• Make sure power is on by opening the door to see if
interior light turns on.
SLIDE PRODUCT INTO THE CUTOUT
5
• Carefully slide the unit into the opening. Be careful not
to entangle power cord.
• Make certain that the door protrudes 1" beyond the
surrounding cabinets.
• Check again to be sure the unit is level.
SET TEMPERATURE CONTROLS
6
• The temperature controls are preset. Refer to the
Temperature Control section for more information.
Allow 24 hours for temperature to stabilize.