light up, and then the kettle starts to boil the water. The kettle will switch off
automatically once the water has boiled. If necessary
it will take you 30 seconds to
,
wait before pressing the switch again to re-boil the water. You may shut off the power
by lifting switch up or directly lift the kettle from the power base at any moment to
stop boiling process.
NOTE: Ensure that switch is free of obstructions and the lid is firmly closed, the
kettle will not turn off if the switch if be constrained or if the lid is opening.
5. Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your kettle as boiling water
may result in scald, besides, don't open the lid while the water in the kettle is hot.
6. The kettle will not re-boil until the switch is pressed again. The kettle may be
stored on the power base when not in use.
NOTE: Always disconnect the power supply when not use.
BOIL-DRY PROTECTION
Should you accidentally let the kettle operate without water, the function of boil-dry
protection will automatically switch off the power. If this occurs, allow the kettle to
cool prior to filling with cold water before re-boiling.
CLEANING AND MAINTENANCE
Always disconnect the appliance from the power outlet and cool it down completely
before cleaning.
1. Never immerse the kettle, power cord or power base in water, or allow moisture to
contact with these parts.
2. Wipe the appearance of body with a damp cloth or cleaner, never use a poisonous
cleaner.
3. Remember to clean the filter at intervals. For easier cleaning, detach the filter by
pressing down the tab of filter inside the kettle and then replace it after cleaning.
CAUTION: Do not use chemical, steel, wooden or abrasive cleaners to clean the
outside of the kettle to prevent the gloss loss.
4. When not use or storage, the power cord may be wind under the bottom of kettle.
5