Trust START-LINE AMST-606 Manual De Usuario página 2

AMST-606 WIRELESS CONTACT SENSOR
EN
COMPATIBILITY
This transmitter works with all Trust Smart Home
receivers.
TECHNICAL SPECIFICATIONS
• Battery 1x 3 Volt CR2032 lithium
• RF frequency 433.92 MHz
• RF range Up to 30 m indoor/70 m outdoor (optimal conditions)
• Switch-off delay Yes (2/4/6/8/10/15/20 minutes)
WIRELESS RADIO SIGNAL
• The 433.92 MHz radio signal passes through walls, windows and doors.
• Indoor range: up to 30 m. Outdoor range: up to 70 m. (optimal conditions)
• The range is strongly dependent on local conditions, such as the presence of metals. For example,
the thin metal coating in Low-emissivity (Low-E) glass has a negative impact on the range of radio
signals.
• There may be restrictions on the use of this device outside the EU. If applicable, check whether this
device complies with local directives.
LEGAL INFORMATION
CE: Trust declares this device complies with the Directives as listed in Section 2 of this document.
WEEE: Dispose of the device at a recycling centre. More information: www.trust.com
Warranty information: www.trust.com/warranty
3
FUNCTIONALITY
Wireless magnetic contact switch for switching
Trust Smart Home receivers on/off when a door or
window is opened/closed.
Read these simple guidelines. Not following them may be dangerous and faulty installation will
invalidate any warranty that may apply to this product.
BATTERY
Remove the battery if the product will not
be used for an extended period. Extreme
temperatures reduce the capacity and lifetime of
the battery.
Replace the battery when the reach of the
transmitter starts to decrease.
Do not crush, burn or shred batteries. Dispose
of batteries according to local regulations.
Please recycle when possible. Do not dispose as
household waste.
LIFE-SUPPORT
Never use Trust Smart Home products for life-
support systems or other applications in which
equipment malfunctions can have life-threatening
consequences.
INTERFERENCE
All wireless devices may be subject to
interference, which could affect performance. The
minimum distance between 2 receivers should be
at least 50 cm.
AMST-606 WIRELESS CONTACT SENSOR
REPAIRING
Do not attempt to repair this product. There are
no user-serviceable parts inside.
WATER-RESISTANCE
This product is not water-resistant. Keep it dry.
Moisture will corrode the inner electronics.
CLEANING
Use a dry cloth to clean this product. Do not use
harsh chemicals, cleaning solvents, or strong
detergents.
HANDLING
Do not drop, knock, or shake the device. Rough
handling can break internal circuit boards and fine
mechanics.
ENVIRONMENT
Do not expose the product to excessive heat
or cold, as it can damage or shorten the life of
electronic circuit boards and batteries.
EN
4