Residual Risks; Intended Use - Rebel RB-1010 Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 40
• Do not use dull or damaged bits and/or accessories. Dull or damaged bits/accessories
have a greater tendency to get jammed in the workpiece, or to break, or to be ejected.
• When installing a bit/accessory in the chuck, insert the shank of the bit/accessory
well inside the chuck. If the bit/accessory is not inserted deeply enough, the grip of the
chuck over the shank of the bit/accessory is greatly reduced likely to increase the risk of
loss of control. After inserting the bit, pull on it, so as to ensure that it is properly locked.
• If the bit becomes bound or jammed in the workpiece, immediately stop the tool by
releasing the trigger switch, then reverse the rotation direction and slowly squeeze
on the trigger switch to release and remove the bit. Be ready for strong reaction
torque likely to cause a kickback.
• Never grasp the tool (the chuck or the bit/accessory) while in motion and never place
your hands too close to the spinning chuck or drill bit. Laceration hazard.
• Never change the rotation direction when the power tool is still running. Ensure that
the chuck has come to a complete stop before changing rotation direction.
• Avoid touching the drill bit just after use, as it may be hot. Similarly, when removing
the bit/accessory from the tool, wear protective gloves to grasp it. Accessories (bits)
may become hot after prolonged use. Avoid contact with skin. Burn hazard.
• Always wait until the chuck and accessory have come to a complete stop before
placing it down.
• Some materials may contain chemicals that can be toxic. Avoid inhalation of dust and
any contact with the skin.

Residual risks

Even when the power tool is used as prescribed it is not possible to eliminate all residual risk factors.
The following hazards may arise in connection with the power tool's construction and design:
• Damage to lungs if a dust mask is not worn.
• Damage to hearing if hearing protection is not worn.
• Health defects resulting from vibration emission if the power tool is being used over
longer period of time or not adequately managed and properly maintained.
• Injuries and damage to property to due to broken accessories that are suddenly dashed.
INFORMATION ABOUT THE POWER TOOL

Intended use

The impact drill is intended for:
• drilling in all types of wood products,
• drilling in ceramics, plastics, fiberglass and laminates,
• drilling in metals,
• impact drilling in concrete, brick or other masonry.
Use the power tool for its intended purpose only. Any other use is deemed to be a case
of misuse. The user/owner of this power tool, not the producer, is responsible for any
damages or injuries caused by improper handling of this power tool.
EN
32

Publicidad

Tabla de contenido
loading

Tabla de contenido