Work Light - Rebel RB-1001 Manual Del Usuario

Fitting and removing screwdriver bits
The power tool chuck is suitable for screwdriver bits with a standard 1/4
inch hexagonal shaft. To fit a screwdriver bit:
• Set the rotation direction switch (4) to the middle position.
• Insert the screwdriver bit into the chuck (1), it will be hold by a magnet.
• The screwdriver bit can be removed by pulling it out of the chuck again.
Rotation direction adjustment
The power tool has been equipped with rotation direction switch (4):
• To achieve right rotation (driving in), push the rotation direction
switch (4) maximally left.
• To achieve left rotation (loosening), push the rotation direction switch
(4) maximally right.
Rotation direction indicators
• With the right rotation set (driving in), „↑" is on.
• With the left rotation set (loosening), „↓" is on.
Switching the power tool on and off
• Pressing the ON/OFF switch (5) will activate the power tool.
• Releasing the ON/OFF switch (5) will stop the power tool.
• Set the rotation direction switch (4) to the middle position to lock
the movement of the ON/OFF switch. It cannot be activated in this
position.

Work light

Above the ON/OFF switch there is a work light (2). It turns on when the ON/
OFF switch is pressed. It turns off when the ON/OFF switch is released.
Do not look directly into the light. Risk of eye damage!
47
EN