Adjusting The Projected Image's Horizontal Roll - Epson ELPMB30 Manual Del Usuario

Adjusting the Projected Image's Horizontal Roll

Warning
v Keep holding the projector until the installation is complete.
v Do not loosen or remove the screws carelessly during horizontal roll adjustment.
The projector may fall and cause an accident.
v Do not apply extra force to the plate or projector during adjusting the plates.
The projector or plates may fall and cause an accident.
v After the adjustment, try re-tightening all the screws again and make sure that all of them are securely
tightened.
Procedure
18
A
If the screws are tightened, slightly loosen the two screws
Loosen these.
using the ball point hex wrench.
B
Adjust the angle by turning the adjustment dial
adjustment dial
Adjustment dial
Adjustment dial
C
Secure these. After angle adjustment is complete, tighten the two screws
firmly using the ball point hex wrench.
.
: Lowers the right side of the projected image.
: Lowers the left side of the projected image.
or