Firstech, LLC. 2W902R-SP Manual De Usuario página 13

on the inside of your windshield.
RPS Touch (Remote Paging Sensor)
The new RPS touch has multiple features including: remote paging, 4 digit pin unlock/disarm, and
arm/lock. All features are operated with a simple touch of the sensor.
Please have your installer program Option 3-16 to Setting 2.
RPS Touch and car call functions do not require programming, however in order to unlock/disarm your
vehicle you must program a 4 digit passcode using the instructions below:
STEP 1: Choose your RPS Touch 4 digit code. '0' is not available.
STEP 2: Turn ignition to the 'ON' position and leave driver's door open.
STEP 3: Hold your finger over the 'Red Circle' icon for 2.5 seconds.
STEP 4: When the siren chirps and LEDs flash in a circular pattern, tap on your first number. (Hold the
number for 2.5 seconds to choose 6 through 10.) After choosing your first number you will get one siren
chirp and LEDs will flash in a circular pattern.
STEP 5: Repeat Step 4 until all four digits are set. You will get 1 siren chirp and 1 parking light flash.
Repeat Steps 2 - 5 if you get 3 chirps and light flashes. Your RPS Touch is now programmed.
Alarm rearm and lock
To rearm hold your finger on the 'Red Circle' for 2.5 seconds.
Alarm disarm and unlock
To disarm hold your finger over the 'Red Circle' for 2.5 seconds. Once the LEDs start their circular
pattern, enter your 4 digit code. (Refer to Step 4 above.) Two seconds after entering the 4th digit, your
system will disarm.
2 Way LCD remote paging
To page a 2 Way LCD remote just tap the 'Red Circle' twice.
Touch Panel Sensitivity
To change touch sensitivity open the driver's door, hold the button on the back of the RPS Touch until
the LEDs go out. Release button and tap again. The number of solid LEDs represent sensitivity of touch,
1 being the lowest, 5 the highest.
RPS Touch On or Off
You can turn the RPS Touch off from your remote. Just follow the instructions below:
STEP 1: Enter remote programming mode by holding down the Trunk and Key/Start buttons <insert
icon> simultaneously for 2.5 seconds. The remote will beep once and the LCD will read "REMOTE
MENU" indicating that you have entered programming mode.
STEP 2 : Scroll through the remote options by taping the Function button <insert icon>. Once the LCD
reads "RPS-ON" tap the Lock button <insert icon> to turn this feature on. The LCD will read "RPS-OFF"
13