Cleaning And Maintenance - Bimar S248 Manual Del Usuario

To change the unit of temperature measurement from °C to °F, press the
seconds or vice versa.
button (3) to select: fan (
fan heater is controlled by the thermostat, and heats to the degree selected: hot air if
selected, very hot air if
heating element is deactivated and only the fan operates, the heating element will begin to heat
again when the temperature drops. If, upon start-up, the room temperature is higher than the
temperature set, the fan heater will not start if it is set to " " or " " mode, but will start-up when
the °C temperature in the room falls below the °C set. If "
operate.
Timer button (5), sets the time of operation, after which the appliance will stop automatically. To
set the time, press the "
hour - 2 hours- 4 hours
time disappears. If the timer is not activated, the device works until it is turned off.
Left-right swing button (6)
The appliance is also equipped with an anti-tip switch, that stops the appliance in the event of a
fall. When returned to a vertical position, the stand-by function is activated.
All of the functions set out above are illustrated by way of a graphic and light on the control panel,
and an LED light (above the On/Off button) indicates the "appliance connected" function.
The appliance can be operated both by using the controls on the control panel, and the remote control.
The remote must be pointed at the display. Before using it, insert the batteries (open the rear flap and
insert 2 "AAA" batteries with correct polarity, close the flap). You will hear a beep for each change
of function.
To use the appliance, connect the plug to the power socket and select the functions as set out above.
To switch off the appliance, press the
seconds (approximately 15 seconds), to cool the heating element. Once it has stopped, move the
switch to position 0, remove the plug from the power socket.
If the appliance is not being used for long periods of time, remove the plug from the power
socket.

CLEANING AND MAINTENANCE

Attention: before cleaning the fan heater, turn it off, remove the plug from the outlet and wait for it
to cool.
• Periodically check that the air-intake grill is not obstructed by fuzz or threads.
• Use a soft, slightly damp cloth to clean the body; do not use metal scouring pads or abrasive
products.
" "
•
•
•
•
), hot air ( ) and very hot air ( ). Set to normal mode, the
is selected: once the °C temperature set has been reached, the
" button repeatedly: each time it is pressed it selects ( 0.5 hours - 1
.7.5 hours ). To deactivate the timer, press the button until the display
: activates or deactivates automatic left-right swing function.
button: the fan will continue to function for a number of
13/37
" "
...
" "
button for a few
" mode is selected, only the fan will
" "
is
" "