GRILLINGIN FLAT POSITION
NOTE: When cooking on both Lower and UPPER plates in FLAT mode ensure that your food is
spread evenly amongst both plates. Always place the food with longest cooking time on the
LOWER plate. When cooking on one plate, only use LOWER plate. In the FLAT position the
Top plate will run 75˚F cooler than the bottom plate.
WARNING: Open the grill using the handle only. Be careful not to touch any hot surface such
as the housing or grill plates. We recommend the use of oven mitts or potholders to prevent the
risk of injury. Extreme care must be used when operating this appliance as surface
temperatures get extremely hot.
When you have finished using your appliance, disconnect the plug from the wall and allow the
unit to cool completely before cleaning.
1. Ensure that your drip tray is in the sliding position and fully under the grill in the center of
the housing. (see Figure 5); and that the DRIP DRAWER is in proper position with it is
fully flush with the front of the housing (see Figure 6).
2. Your grill will not properly preheat unless the grill it is in the closed position. (see Figure
6).
3. Close the top housing and plug into a 120-volt 60HZ AC grounded outlet only. The red
light will turn on indicating that the appliance is preheating. After approximately 3
minutes, the green light will turn on indicating that the appliance is preheated and ready
for use.
4. Press the GRILL LOCKS button in (see Figure 3) and open your grill using the handle to
the FLAT position (see Figure 2).
5. When you have finished using your appliance, disconnect the plug from the wall and
allow the unit to cool completely before cleaning.
NOTA: The green ready light is thermostatically controlled and will cycle on and off during
cooking to ensure that the correct temperature is maintained.
8