Sinbo SKS 4515 Guia Del Uso página 8

MOUNTING THE SCALE ON A WALL
scale is equipped with one wall mount bracket at the top and another at the bottom on
the back of the scale. Remember to insert the batteries before the scale is mounted on
a wall. Use the enclosed template for drilling holes in the wall or other surface to ensure
that the holes are drilled correctly in relation to each other. Make sure that the scale is
mounted on both screws, and that the screws are sufficiently well mounted. Otherwise
the weight might fall down during use due to load and gravity.
Setting the clock
The scale is equipped with a 24-hour clock which can be read from the display when the
scale is not in use as a weighing instrument. Consequently, the time should be set before
the scale is taken into use.
The time is set by pressing and holding the MODE button for a few seconds. Subsequently,
the hour digits start flashing. Set the hours using the TARE button – when the required
hour digits appear on the display, confirm by pressing MODE. The minute digits then
start flashing. Set the minutes using the TARE button again and confirm by pressing
MODE when the required minute digits appear. The digits will change more rapidly if the
TARE button is held.
Weighing
Fold the weighing lever downwards and press the ON/OFF button lightly to activate the
scale. After a few seconds the scale display reads "0". Then select measurement unit
by pressing MODE (it is also possible to shift between measurement units during weighing
by pressing MODE). The scale is now ready for use. The scale can weigh up to a maximum
of 3 kg.
Resetting
This kitchen scale is equipped with a practical reset function which enable all ingredients
to be weighed directly in the same bowl, one at a time. When you have finished weighing
the first ingredient, the scale is reset by a quick tap on the TARE button. When the scale
reads "0" again, it is reset and ready for weighing the next ingredient. Remember to
reset after weighing each ingredient.
If the most recently weighed ingredient is removed again after resetting, its weight will
be displayed with a negative sign. The scale is reset again by pressing TARE. If the scale
is overloaded (a load of more than 3 kg), the display will read "err". Remove the surplus
ingredients from the scale and press TARE for resetting. The scale will then be ready
for weighing again.
Switch-off
To save battery life the scale automatically switches off following approximately 60
seconds of non-use.
The scale can also be switched off manually by pressing the ON/OFF button.
- 7 -