Maintenance Instructions - Gardebruk Deuba 107834 Manual Del Usuario

INSTRUCTIONS
4
ATTENTION! Read the safety and assembly instructions carefully, in order to avoid
the risk of injury or damaging the product.
Important: Read these instructions carefully and thoroughly. Keep these instructions
to read through at a later date. If you give the product to anyone else at some point
in the future, please ensure you also pass on this manual
Only for domestic use and not for
commercial use!
.
Keep small parts, plastic bags and other packaging out of the reach of children.
Pay attention especially when unpacking your item. Danger of suffocation!
Check the delivery for completeness. Later complaints cannot be accepted.
Check all elements and parts for damages. Despite careful control, products may be
damaged in transit. In this case, do not assemble your product. Defective parts can
endanger your health.
Never modify the product! Changes will void the warranty and the product may
be unsafe or even dangerous.
Unpack all the parts and elements of the set and place the components on the top of
the carton or other clean surface. This protects your new product.
Please also pay attention not to scratch the floor while working with tools.
Make sure that this product is fully assembled before use, as shown in the illustration
For cleaning use a sponge and warm soapy water. Do not use solvent based-cleaners or
detergents - for example bleach. Those can damage the product.

Maintenance Instructions

After Each Use: Wash unit Thoroughly and let it dry. Lubricate
moving parts, including slide plate, axle and upright Shaft.
Caution:
Care must be taken with any weed killer, pesticide or combination
product. They can be harmful to other plant live in the yard.
Caution: The max load capacity is 25 kg (55.11 lbs).
www.DeubaXXL.de
4
Push the calibration switch down and set the control lever to the desired number.
Assembly
Fasten both funnel supports (4) to the bottom of the funnel with one Phillips screw
1.
M6x38mm (9) and one Nylstop nut M6 (13).
Screw the nut (13) on both supports (4) onto the Phillips screws (9) only so far that
the supports can still be moved.
Next, slide the separating sleeves (11) onto the axle of the gearbox housing (2).
(1xLeft & 1x Right/see figure below) Now guide the axle through the axle holes of
the hopper supports (4). Then push the spacer sleeves (12) also one left and one
right onto the axle. Now you can correctly fasten the screws on the funnel supports
(4).
Push one wheel (7) each onto the two axle ends.
2.
Then a washer (18) on each side.
Next, insert the split pins (3) in the holes provided for them at the ends of the axle
and then fasten them.
Finally, place the hubcaps (8) on the axle ends and secure them with light, light
hammer blows until the hubcaps (8) are flush with the wheels.
Now fasten the foot (6) to the funnel supports (4) with Phillips screws (9) and
3.
Nylstop nuts
Now insert the larger cotter pin (3) completely through the holes at the end of the
4.
rotary axis to lock the rotary disk (2) to the hopper (1).
Now connect the handle (5) to the foot (6) using the carriage bolts (16) and
5.
triangular nuts (10).
Fasten the control lever (14) to the handle (5) using the pre-assembled Phillips
screws M6x48mm (17).
Operating the spreader
OPEN: Push the control lever forward until it stops at the
switch.
CLOSE: Pull the control lever back completely in your direction.
5
DIN94
Kreuzschlitzschraube/ phllip
M6x38mm/ DIN7985
/vis á tête cruciforme
Dreiecksmutter triang
triangle écrou
www.DeubaXXL.de
13mm