Berker 7531 30 04 Manual De Instrucciones página 11

GB
• Connection of different phases to terminals A1 – A3.
• Switching and dimming behaviour presettable with
parameters.
• Checkback for switching status.
• Transmission of brightness value
• Soft-On, Soft-Off and delayed dimming presettable with
parameters.
• Light-fading mode and immediate brightness change.
• Lightscape operation possible.
• Behaviour on bus voltage return presettable.
Characteristics Important information
• The number of electronic ballasts that can be dimmed via the
1-10 V interface, depends on the ballast-specific load current
of the types used.
• Please observe: electronic ballasts produce high peak
currents during switch-on, which might cause the relay
contacts to stick together. For loads up to max. 200 VA per
channel we recommend using an inrush current limiter
(Best.no. 0185).
• For greater loads we recommend using separate load-
switching relays.
GB