Decimal Point; End Of Programming - Kübler CODIX 529 Instrucciones Para La Puesta En Servicio

4.4 Min. value display
Min. value can be displayed
Min. value will not be dis-
play ed, next menu item is
skip ped
4.5 Min. value reset
Min. value can be reset by
pressing the red button
(cur rent value becomes new
min. value).
Min. value cannot be reset.

4.6 Decimal point

The decimal point indicates
the num ber of decimal
places.
0
0.0
0.00
0.000
0.0000 four decimal places
4.7 Min. input signal (only if input
signal range is 4...20 mA or 2...10 V)
This menu item allows a limitation of the dis-
play range (refer to 4.9 and 9.4)
a) or b) is selected depend-
ing on the chosen input
range
a)
If, with the input range
4...20 mA, the input signal
level be co mes smaller than
this value, the display shows
„lo".
If, with the input range
b)
2...10 V, the input signal level
be co mes smaller than this
value, the display shows „lo".
no decimal place
one decimal place
two decimal places
three decimal places
4.8 Displayed value at min. input signal
A corresponding display
value between -19999 and
99999 can be as si gned to
the lowest input signal. The
decimal point position is
considered.
4.9 Max. input signal (only if input
signal range is 4...20 mA or 2...10 V)
This menu title allows a limitation of the display
range (refrt to 4.7 and 9.4)
a) or b) is selected depending
on the chosen input range
If, with the input range
a)
4...20 mA, the input signal
level exceeds this value, the
display shows „hi".
If, with the input range
b)
2...10 V, the input signal
level exceeds this value, the
display shows „hi".
4.10 Displayed value at max. input signal
A corresponding display
value between -19999 and
99999 can be as si gned to
the highest input signal. The
decimal point po si ti on is
considered.

4.11 End of programming

Programming routine will
be passed through once
again. All parameters can be
checked.
Programming routine will be
left and the new pa ra me ters
will be stored. Af ter wards the
device is ready to use.
Page 3