Tabla de contenido
Publicidad
Park Distance Control (PDC)
BMW 5 Series (E 39), only vehicles from 03/1998
Only for use in the BMW trading organisation.
Installation time approx. 1 - 2 hours, which can
vary according to the condition and fittings of the
vehicle.
Electrical knowledge is required.
Attention!
Take care to see that the supplementary wiring
harness and the vehicle wiring harness do not get
damaged and that no chafing marks can occur.
Required tools and auxiliary materials
Phillips screwdrivers
Socket wrench 10 mm
Flat-tip screwdrivers
Drill Ø 3 mm, Ø 10 mm
Zinc dust paint
Open-ended spanner SW 16 mm
Side-cutting tool
Electric torch
Drilling machine
Step drill Ø 40 mm
Round file
2. Overview of the supplementary wiring harnesses
F 39 0118 EVA
Item Package / Designation
Ultrasonic sensors wiring harness
A
3-pole black connector X18020
A1
3-pole black connector X18021
A2
3-pole black connector X18022
A3
3-pole black connector X18023
A4
12-pole white connector X18013
A5
Power supply wiring harness
B
2-pole black connector X362
B1
Plug contact term. R of fuse F61 output
B2
Contents
1. Necessary preparatory work on the vehicle
6. Install PDC speaker
1. Necessary preparatory work on
the vehicle
- Print out error memory
- Disconnect battery
- Dismantle boot trim panels
- Remove bumper guards from rear bumper
- Dismantle bumper
- Dismantle rear window shelf
Connection point in vehicle
Cable
colour
-
-
Ultrasonic sensor rear left
-
Ultrasonic sensor rear centre-left
-
Ultrasonic sensor rear centre-right
-
Ultrasonic sensor rear right
-
PDC control unit A81 in boot, rear right
-
-
PDC speaker under rear window shelf
violet/black
Fuse holder A49 in boot right above the
battery
Code design. /
plug-in place
X18020
X18021
X18022
X18023
X18013
X362
X10018/12
EN/9
Publicidad
Capítulos
Tabla de contenido
