Axxess AX-ADFD100 Instrucciones De Instalación página 6

The following wires are for the aftermarket radios that have navigation built in.
• Connect the Light Green wire to the parking brake wire.
• Connect the Blue/Pink wire to the VSS or speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
From the LD-AX-ADFD02 harness:
(a) 22-pin harness to the aftermarket radio:
The DIN plug is for future applications.
(b) 24-pin harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the constant wire.
• Connect the Blue wire to the antenna turn-on.
• Connect the RCA jacks labeled "From 3.5" to the audio AUX-IN jacks
on the aftermarket radio (if SYNC is not present).
These wires are only to be connected if the vehicle does not have the SONY/THX system .
• Connect the Violet wire to the right rear positive wire.
• Connect the Violet/Black wire to the right rear negative wire.
• Connect the Green wire to the left rear positive wire.
• Connect the Green/Black wire to the left rear negative wire.
AX-ADFD100
Connections to be made
12-pin pre-wired ASWC-1 harness:
This harness is to be used along with the optional ASWC-1 (not included) to
retain steering wheel audio controls. If the ASWC-1 is not being used, disregard
this harness. If it will be used, please refer to the ASWC-1 instructions for radio
connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
• Connect the Red wire to the accessory wire.
6
(c) 26-pin harness to the aftermarket radio:
• Connect the RCA jacks labeled "RSE/SYNC/SAT" to the audio
AUX-IN jacks on the aftermarket radio (if retaining rear seat
entertainment, SYNC, or satellite radio).
Note: Most Ford radios have satellite radio built into the radio,
so this feature is lost if so.