Cleaning And Maintenance - Eldom COLUMBIA VAC OK200 Manual De Instrucciones

NOTE! The filters (20 and 22) can be used together. It is not recommended to use the
filter (21) with other filters because of the vacuuming performance.
- put on the paper bag (24) – Fig. 9. The paper bag can be used with filters (20, 21),
- dry surfaces can be vacuumed in either a bagless configuration or with the bag attached.
In bagless operation, the dust is collected directly in the container (5),
NOTE! Vacuuming with the bag (24) is recommended. Operation without a bag
results in faster clogging of the filters.
- put the lid (3) on the container (5) and lock it with the clamps (7),
- connect the hose (12) with the suction pipe (13) and the installed attachment (14, 15 or
16),
- connect the appliance to a power supply with the parameters specified in the manual,
- turn on the appliance using the switch (2),
- press the switch (2) to stop the appliance,
- clean the appliance after the work is finished – see CLEANING AND MAINTENANCE.
Vacuuming wet and damp surfaces
- remove the lid (3) – see "ASSEMBLY"
- pull the sponge filter (23) over the basket (17),
NOTE! Do NOT use other filters and the paper bag (24) for wet operation
- put the lid (3) with the installed filter (23) on the container (5) and lock it with the clamps
(7),
- connect the hose (12) with the suction pipe (13) and the installed brush (14) or nozzle
(16),
NOTE! Do NOT use the multifunction brush (15) for wet operation
- connect the appliance to a power supply with the parameters specified in the manual,
- turn on the appliance using the switch (2),
- press the switch (2) to stop the appliance,
- clean the appliance after the work is finished – see CLEANING AND MAINTENANCE.
Blower function
- insert the thicker end of the hose (12) into the port (9) and lock it in place.
NOTE! The best effect is achieved when the vacuum cleaner is emptied of any waste
and no filters are fitted.

CLEANING AND MAINTENANCE

- before performing any maintenance or repair works, turn the vacuum cleaner off and
disconnect it from the power supply.
- regular cleaning and replacement of the filters (20, 21, 22, 23) and emptying the
container (12) will ensure a failure-free operation of the vacuum cleaner,
- clean the vacuum cleaner's housing, the tools and accessories, and the power cord with
a soft cloth slightly dampened with water and a small amount of dishwashing liquid,
- dry all parts thoroughly before reusing them,
do not immerse the vacuum cleaner in water,
-
- do not use any aggressive cleaning agents to clean the vacuum housing; otherwise, its
surfaces can be damaged.
16|EN EN|16