Introduction; Main Safety Precautions - Skyfood LT-2,0 SUPER GOURMET 2 Manual De Instrucciones

1. Introduction

1.1 Main Safety Precautions

When using this equipment, keep in mind some basic safety precautions:
1.1.1 Read all the instructions.
1.1.2 In order to avoid the risk of electric shocks and damage to the machine, never install
equipment on a wet or humid surface nor dip it in water or any other liquid.
1.1.3 The use of the equipment must be supervised when used next to children.
1.1.4 Before cleaning and when not in use or before inserting or removing accessories,
disconnect machine from power source.
1.1.5 Never touch parts of the machine while on movement.
1.1.6 Do not use the equipment if cord or plug is damaged. Do not use the equipment if it
is not working correctly, nor if it has been damaged in any way. In case that happens, take
the equipment to the nearest Technical Assistance to check it up.
1.1.7 The use of accessories not recommended by the manufacturer may cause personal
hurt.
1.1.8 Keep your hands or any tool out of the machine while operating to avoid personal
hurt or any damage to the equipment. If it is needed to mix etc. switch OFF and unplug the
blender, use only a rubber spatula.
1.1.9 The knives are very sharp. Be careful while handling them.
1.1.10 – Always put the lid on the blender before turning it on.
1.1.11 – Always hold the cup while the blender is working. If the cup gets loose, immediately
turn the machine off.
1.1.12 – Do not use the machine outdoors.
1.1.13 – Do not leave the electric cable on the edge of the table or counter nor let it touch
hot surfaces.
1.1.14 – Do not leave your blender working without supervision.
1.1.15 – Never use water spray directly upon the machine.
1.1.16 – Never turn the machine on with wet clothing or feet.
1.1.17 – Do not operate the equipment with the blade loose, disassembled or damaged.
1.1.18 - For your safety, the temperature of the processed products shall not exceed 40 °
Celsius / 104° Fahrenheit.
Your machine has a thermal relay N°08(Pic.01) that monitors the motor temperature and
automatically turns the motor off in case of overheating.
To restart it, remove the cup from the base and wait until the motor cools down. After the
motor is cool replace the cup and press the button located in the back of the machine.
4