Cleaning And Maintenance - Eldom sandy PP10 Manual De Instrucciones

CHARGING AND OPERATING THE DEVICE WHEN BATTERY-POWERED
- turn off the device by pushing the switch (4) down (Fig. 2)
- plug the AC adapter (6) to the port in the device (7) and then to a wall socket (Fig. 3)
- charging is indicated by a red light (5). Battery charging time is approximately 8 hours.
NOTE: The indicator light (5) does not go off when charging is completed.
- when charging is completed, disconnect the power cable from the wall socket and from the
device port (7),
- the device is ready for battery-powered operation
- to start, push the switch (4) up (Fig. 1)
Charging the battery for longer than 12 hours shortens its lifespan. If the device is not used for
a long time, it is recommended to charge the battery at least once per every six months. If the
battery is not charged for the period longer than six months, its lifespan also gets shortened.
USING THE DEVICE
PP 10 Electric Foot File is intended to be used only to smooth the hard skin of your feet and
heels.
- wash and clean the skin, then dry it carefully.
CAUTION: Do not use the device on wet skin
- remove the cover (1) and make sure that the roller (2) is properly installed
- turn on the device by pushing the switch (4) up (Fig. 1)
- gently run the roller on your skin for 2-3 seconds. No not press hard. The device will stop if it is
pressed too hard on the skin.
- stop and check the results. Continue until the desired level of smoothness is obtained.
Warning: Do not use the device on reddened or inflamed skin as well as on the warts and open
wounds. Stop using if skin becomes sore or irritated.
Warning: Do not use on skin for longer than 2-3 seconds at a time.
- turn the device off by pushing the switch (4) down (Fig. 2)
- rinse the skin or use a wet towel to get rid of the dead particles
- clean the device immediately after using it
- keep the protective cover (1) on your device when it is not used.
Keep the operating device away from the hair on your head, eyebrows, eyelashes and also
away from clothes, cables, laces, etc.

CLEANING AND MAINTENANCE

- clean the device after every use. To do that, push the safety switch lock (3) and remove the
roller (2) (Fig. 4). Protect the roller (2) against drop.
- clean the roller head (2) using the brush (8) included in the set.
- the roller (2) may be rinsed under the tap water
- do not submerge the entire device into water or other liquids
- do not use strong or surface damaging cleaning agents or products
- wipe the body of the device with a moistened cloth
Do not turn the device on during cleaning
If the roller (2) is cleaned with water, dry it carefully before the next use.
9