Dometic 10 Serie Instrucciones De Uso página 20

Troubleshooting
RC10.4S.70, RC10.4S.90, RC10.4P.100, RCL10.4(E)S, RCD10.5(X)S,
RCS10.5(X)S
In the event of a fault, the warning LED (
fault.
All faults of the WARNING (W) type are reset automatically once the fault has been
rectified.
All faults of the ERROR (E) type must be reset manually:
➤ Press
for 2 seconds.
✔ A beep sounds.
✔ The error has been reset.
Number of
Audio alarm
flashes
continuous
1
2
3
4
5
6
-
20
Fault type
No W
Yes W
Yes E
Yes E
Yes E
Yes E
No W
Yes W
in the display flashes according to the
)
Fault
Defective temperature sen-
sor in the refrigerator com-
partment
DC voltage <7.5 V
Outer fan overcurrent
Compressor does not start
Compressor overload
Thermal cut out compressor
controller unit
CI bus fault
Door open for more than
2 minutes
RC(S)(L)(D)
Solution
➤ Contact an author-
ized customer ser-
vice point.
Resets automatically
➤ Press the on/off
button for at least
2 seconds.
➤ Press the on/off
button for at least
2 seconds.
➤ Press the on/off
button for at least
2 seconds.
➤ Press the on/off
button for at least
2 seconds.
Resets automatically
➤ Close the door.
EN