Technical Data; How To Use The Appliance - Eldom skin G46S Manual De Instrucciones

GENERAL DESCRIPTION
1. Shaving head with three blades
2. Opening button for
the shaving head housing
3. On/off switch
4. Indicator
5. Socket for the power cable
6. Trimmer
7. Trimmer opening button

TECHNICAL DATA

- power: 3W
- mains voltage: 230V ~50Hz
- charging time: about 8h
- battery:
Ni-Cd 600 mAh

HOW TO USE THE APPLIANCE

- The appliance can be used after charging the battery or by connecting to the mains –
power cable should be properly connected to the socket (5).
- The shaver starts working after switching the switch (3)
- In order to turn off the appliance, the switch (3) should be switched again
- The appliance is equipped with an internal battery. Charging time is about 8 hours.
- In order to increase the battery life-span charging should be done in one uninterrupted
cycle after full discharging
- Charge is indicated by a control light (4). The indicator light does not turn off when the
battery is charged.
- After charging, the appliance should be disconnected from the mains and the power
cord should be unplugged from the socket (5).
- The appliance is equipped with a trimmer (6) to cut beard , which is activated by the
switch (7).
CLEANING AND PRESERVATION
- Before cleaning turn off the appliance and remove the power cable from the socket
- The whole appliance cannot be submersed in water
- After each shaving the blades chamber should be empty. In order to do it you must
remove the shaving head housing by pressing button (2). In order to clean the appliance
the attached brush should be used.
- Do not use any cleansing agents which are strong and damage the surface
- Wipe the housing with a moistened cloth
OPERATING MANUAL
6
7
8
ELECTRIC SHAVER G46S
2
1
3
4
5