INSTRUCTION MANUAL
EN
VACUUM CLEANER OB20B
GENERAL DESCRIPTION
1
Power switch
2
Suction power control
3
Battery power indicator
4
Vacuum housing
5
Wand release
6
Wand adapter
7
Wand
8
Storage bracket
9
Motorized brush tool
10
Brush tool light
11
Brush tool adapter
12
Brush tool release
13
Dust canister release
14
Dust canister lid
15
Dust canister
16
Filtering unit
a. HEPA filter
b. Intake filter
17
Storage catch
18
Power charger input receptacle
19
Handle
20
Brush tool shaft
21
Brush tool shaft release
22
Power charger
23
Wall mount
24
2-in-1 crevice tool
TECHNICAL DATA
Rated power: 130W
Supply voltage: 100-240V, ~50 Hz
Maximum vacuum: 12kPa
Operating voltage: 22.2V
Charging voltage: 26V
Volume: <80dB
Operating times after full charge
- at high speed for up to 20 minutes,
- at low speed for up to 30 minutes.
Dust-container capacity: 0.5l
Battery: Li-ION 22.2 V, 2200 mAh
BATTERY
-
The vacuum cleaner can only be used if the integrated battery pack is fully charged. The charging time is approximately
5 hours.
-
After unpacking and assembling the vacuum cleaner, charge the battery pack.
-
Charge the vacuum cleaner at room temperature.
-
The battery power indicator (3) flashes when charging and lights up continuously when the battery pack is fully charged.
To extend the battery pack life, the first recharging should be done without any interruption and after the battery pack is
completely drained.
-
To extend the battery pack life, the first 3 recharging cycles should be done without any interruption, with each cycle after the
battery pack is completely drained.
-
A fully charged vacuum cleaner will run at full suction power for about 20 minutes. Then the suction power drops rapidly and
the vacuum cleaner will need to be recharged.
-
If the vacuum cleaner is not used for a long time, charge it at least once every 6 months.
Plug the power adapter cable (22) to the power adapter input receptacle (18). Plug the power adapter (22) cord to a power
-
outlet with the mains ratings which match the appliance ratings specified in the manual.
Once the battery pack has been fully charged, unplug the power adapter (22) from the mains and unplug the power adapter
-
cable from the input receptacle (18).
10 EN
1
2
3
4
5
6
7
8
12
9
11
10
19
18
16a
17
16
16b
15
13
14
24
22
23
20
21