Getting Started - Waterpik 200 Serie Manual Del Usuario

6

GETTING STARTED

Insert
Eject
Fill
O
I
1 2
3
Power
O
I
ON
2
1
High
3
O
I
Low 2
1
3
O
2
1
3
Inserting and Removing Tips
Insert tip into the center of the Water Flosser handle. The colored ring will be flush with the top of the handle if the tip is correctly locked
into place. To remove tip from the handle slide the tip eject button up towards the top of the handle and lift tip from handle.
Powering the Unit
Plug the cord into an electrical outlet. If the outlet is controlled by a wall switch, be sure it is turned on.
Preparing the Reservoir
Remove the reservoir and fill with lukewarm water. Replace the reservoir over the base and press down firmly.
Prime Unit (First Time Use Only)
Set pressure control dial on base to high, point the handle and tip into sink. Turn unit ON (I) until water flows from the tip. Turn unit OFF (O).
Adjusting the Pressure Setting
Turn the pressure control dial on the base of the unit to the lowest setting (pressure setting No. 1) for first-time use. Gradually increase
pressure over time to the setting you prefer – or as instructed by your dental professional.
Recommended Technique
For best results, start with the back teeth and work toward the front teeth. Glide tip along gumline and pause briefly between teeth.
Continue until you have cleaned the inside and outside of both the upper and lower teeth.
Lean over sink. Direct the stream at a 90-degree angle to your gumline with tip in mouth. Slightly close lips to avoid splashing
but allow water to flow freely from mouth. Set pressure at desired setting and turn the unit ON (I). Begin cleaning.
When Finished
Turn the unit OFF (O). Empty any liquid left in the reservoir. Unplug the unit.
NOTE: If you used a mouthwash or other solution besides water, see "Using Mouthwash or Other Solutions" section.or as instructed by
your dental professional.