Step 10: Fans - Connecting Cables - ekwb EK-AIO Elite 360 D-RGB Manual De Instalación

D-RGB Header
RGB Header
D-RGB Header (7x)
HUB
4-pin PWM Header (7x)
SATA
4-pin "Red" PWM Header
PWM Header to
Motherboard (1x)
D-RGB Header to
Motherboard (1x)
Fan D-RGB LED Light
Connector
Fan Connector
Step B:
Plug the 3-pin connector of the pump's
D-RGB LED light into the D-RGB HEADER on
the motherboard or into one of the D-RGB
(Addressable RGB) HEADERS on the HUB. The
LEDs will work if the pin layout on the header is
as follows: +5V, Data, Empty, Ground. With
some motherboards, you can alternatively
use a VDG connector instead of the D-RGB to
connect the LEDs.
Please ensure that the arrow
indicated on the connector
plugged into the +5V line as
indicated on your motherboard. If
you put LED Diode to the 12V RGB
HEADER you can damage the LEDs.
Connector is the same on D-RGB
and RGB versions, but D-RGB
version has 3 cables from connector
to PCB; RGB version has 4 cables. If
you connect D-RGB led to ordinary
RGB header you can damage your
motherboard or LED strip.
STEP 10: FANS – CONNECTING
CABLES
is
Fan
Connector
D-RGB Header
RGB Header
- 8 -
EK-AIO Elite 360 D-RGB / EK-AIO Elite 280
D-RGB
Step A:
Plug all of the 4-pin PWM fan connectors into
PWM headers on the HUB (x6 / x4). Make sure
the red PWM header on the HUB is always used.
Plug the PWM connector from the HUB
directly into the CPU fan header on the
motherboard. Always use the CPU fan header
if possible.
Step B:
Plug the D-RGB connectors of the fans into the
D-RGB HEADERS on the HUB (x6 / x4).
Plug the D-RGB connector from the HUB
directly into the motherboard.