N-Gear MOVE WASH LIGHT 7 Manual De Usario página 4

Panel introduction
Master Slave Fixture linking
1. Connect the(male) 3pin connector side of the DMX cable to the output (female) 3pin connector of
the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3pin
connector to the input connector of the next fixture consisting of a (male) 3pin connector. Then,
proceed to connect from the output as stated above to the input of the following fixture and so on.
Orientation
This fixture may be mounted in any position provided there is adequate room for ventilation.
Operating instructions
Navigating the control panel
Access control panel functions using the four panel buttons located directly under the Display.
Menu map
Six distinct operating modes, many with sub-modes, are supported by the unit. To selected use the
"MODE'ESC" button to enter the menu. "UP" and "DOWN" button choose from values available with
the "ENTER" button confirming any selection. After a few seconds, the LED Display will back during
operation until another button is pressed In -built Program Mode
User Configurations
Setting Maximum Pan Angles
To select. use the "MODE ESC"button and choose "PA18","PA36",or"PA54"."UP"and "DOWN"buttons
cycle between all available Pan Angles . Press the "ENTER"button to confirm the chosen selection.
LED Display Maximum Pan
PA18 180°
Pa36 360°
Pa54 540°