RIB ACG9433D Manual De Instrucciones página 13

SIG
CONNECT MAX 2 KEYPADS IN THE
CARD - B -
(to connect in parallel).
to do programming procedure
connect only 1 KEYPAD in the card
- B -.
TURN OFF POWER SUPPLY BEFORE
YOU CONNECT THE CARD
WIRED KEYPAD PROGRAMMING
Card - B - is 2-channels, so it is possible to manage 2 systems or separate commands.
To program codes of the outputs:
CH1 = Digit the numeric code and confirm pressing A button.
CH2 = Digit the numeric code and confirm pressing B button.
- Remove cover - A - from receiver box cod. ACG9159D.
- Do conections as on scheme.
- Power supply card - B - with 12V or 24V ac/dc
- Press and maintain pressed button - C -. You have 5 seconds to digit the code (min. 4
/ max 9 numbers) and confirm pressing button A or with button B. You hear a "BEEP"
to confirm the record of the new code.
- Release button - C - .
- Repeat these steps for every new code to record.
- Close receiver box cover - A -.
SIGNALS
no "BEEP"s = code to record.
1 "BEEP" = code recorded.
WIRED KEYPAD - CONNECTIONS AND PROGRAMMING
channel A
channel B
ATTENTION:
ATTENTION:
12/24 V ac/dc
- A -
- B -
CH1 CH2 SIG
C NA C NA
MAX
24V 1A
2 "BEEP" = if code is already present in the memory.
3 "BEEP" = after deletion of one code.
4 "BEEP" = during deleting procedure. Code not present in memory.
5 "BEEP" = memory full (max 60 codes).
10 "BEEP" = All codes deleted.
DELETING ONE CODE
Press and maintain pressed button - C - up to obtain a permanent "BEEP".
Digit the code to delete (3 "BEEP" follows to confirm deletion).
Release button - C -.
DELETE ALL CODES
Press and maintain pressed button - C - up to when permanent BEEP stops. (10
"BEEP"s follow to confirm total deletion).
Release button - C -.
Wired Keypad has backlighted buttons.
13
G
B
code ACG9159D
- C -