MAAX 107223 Instrucciones De Instalación página 12

Installation Procedure
Temporary Bracing
Install temporary bracing to hold the three panels in place until
the silicone holds the panels completely in place (typically 24
hours).
IMPORTANT NOTICE
To ensure contact between the panels and walls until the
silicone sets, install temporary bracing after completing
installation. The bracing should be constructed from lengths of
2 x 4's. Failure to brace in the manner described could keep
the panels from adhering, resulting in personal injury, as well
as water damage or other damage to floors, walls, or other
portions of your building or home.
IMPORTANT NOTICE
To prevent scratches or other damage, make sure there are
no nails or other foreign objects in the surface of the bracing
that is placed against the panel.
If the horizontal braces are fastened to the vertical braces
using nails or screws, make sure the fasteners do not
penetrate the surface of the panel. Also, to prevent possible
damage to the walls, do not apply excessive pressure to the
braces.
Corner Installation:
For corner shower wall installation use the following illustrated
bracing design.
ATTENTION: Additional bracing may be required if the
wall panel does not make full contact to the
wall it is adhered to.
Attach this
board to
the wall
These boards need to
be attached to the two
outlying boards
Alcove Installation:
1. Place two or three braces against the back wall. Place two
braces on panels that are 48" or less and three braces on
panels greater than 48" wide.
2.
3. Install (wedge) three horizontal braces (six total) against
the left and right wall braces.
Attach this
board to
the wall
12
Place two braces against each left and right wall.