Replacing The Fuse; Technical Specifications - TechGrow Clima Control Basic Plus 14A Manual

Replacing the fuse:

If a short circuit occurs by overload of the fan(s),
the fuse will blow.
If in rare cases the Clima Control Basic Plus does
not operate, it could also indicate that the fuse has
blown.
In these cases the fuse must be replaced.
The fuse is placed left on the front side of the
controller.
Remove the fuse from the black casing by using a
fl at screwdriver.
Now, the fuse can be replaced by a new one.
One spare fuse is supplied.
Put the new fuse in the black casing and place
them back in the holder.
Rotate the screwdriver a quarter turn to the right
to close.

TECHNICAL SPECIFICATIONS:

Power supply:
Net frequency:
Consumption:
Maximum fan capacity:
Adjustment range temperature:
Adjustment range hysteresis:
100 to 240 Volt
50 to 60 Hz
3 Watt
7 Amp / 1700W
14 Amp / 3400W
10.0 - 45.0 °C
1.0 - 7.0 °C
7