Recorder Menu Screen - JVC BD-X200E Instrucciones

Setup Menu

RECORDER MENU Screen

The following table identifies and describes the parameters that may be set using the RECORDER screen.
Top half : Appearance on monitor screen
Bottom half : Appearance on LCD display
[ ] : Default setting
RECORDER MENU (1/2) screen
Parameter Possible settings
CHAPTER
CREATION
CHAPTR
SET INTERVAL
[Every05min]
INTERV
TOTAL
CONTENTS TIME
CNTENS
ENCODE
QUALITY(Mbps) Setting range
described on right.
QUALITY
AUDIO ENCODE
[DOLBY DIGITAL]
A ENC
ASPECT
LETTER BOX
ASPECT
†
MENU
E-80
[MANUAL] This parameter is used to indicate whether or not chapters are to be created
automatically at set intervals while recording.
AUTO
MANUAL : Chapters are not to be created automatically.
[MANU]
AUTO AUTO
Every01min This parameter becomes active whenever CHAPTER CREATION has been set to
AUTO.
It is used to set the time interval for automatic chapter creation and is set in units of
minutes.
Every59min
1
[5]
59
[NO USE] If you already know the duration of the video to be recorded, this parameter can be
set to the corresponding time to allow your BD-X200 to select the optimum encoding
0:01
bit rate.
(Make a setting in hours and minutes between 00:00 and 9:59.)
9:59
● If the recording time is set using this parameter, ENCODE QUALITY will be set
automatically, and this setting may not be modified manually.
[000]
● If this function is not to be used, set it to NO USE.
001
When this setting is made, ENCODE QUALITY will be returned to its previous
959 setting.
[8.0] This parameter can be set when TOTAL CONTENTS TIME has been set to NO USE.
Specifically, it allows direct setting of the encoding bit rate (i.e., the amount of data per second).
The actual setting range depends on the setting that has been made for AUDIO
ENCODE.
[8.0] LPCM
DOLBY DIGITAL : 2.0 to 9.0 Mbps (in 0.2-Mbps steps)
MPEG
LPCM This parameter is used to set the encoding format for audio data.
LPCM
MPEG DOLBY DIGITAL : Dolby AC3 encoding (Compressed)
MPEG
LPCM
[DD]
MPEG
[AUTO] The screen aspect distinction signal of recorded video is selected.
4:3 AUTO
SQUEEZE 4:3
LETTER BOX : Constantly records aspect distinction signal of letterbox video.
[AUTO] SQUEEZE
4 3
LETT Note
SQUE
Setting this item to LETTER BOX or SQUEEZE will not change the output image
during recording and is reflected only in the recording to the disc.
This button is used to display the RECORDER MENU (2/2) screen.
This button is used to return to the Setup Menu screen.
Description
Use this setting when chapters are to be set manually.
: Chapters are to be created at set intervals during recording.
The SET INTERVAL parameter below is used to specify this interval.
: 4.0 to 7.8 Mbps (in 0.2-Mbps steps)
: 2.0 to 9.0 Mbps (in 0.2-Mbps steps)
: Linear PCM encoding (Non-compressed)
: MPEG encoding (Compressed)
: Aspect distinction signal is recorded according to the screen aspect
ratio of the input video.
: Constantly records aspect distinction signal of 4:3 aspect ratio.
(Content at the top and bottom of the screen is blackened out.)
: Constantly records aspect distinction signal of squeezed video.
(Content at the left and right of the screen is compressed.)