Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CONTENTS
(1) GREASE
DAMPER / DUCT
FILTER
(1) PARTS BAG** CONTAINING:
(5) #10 X 5/8"
RD. HD.
MOUNTING
SCREWS
PREPARE THE HOOD
7
Remove all
protective polyfilm
from the hood
(stainless steel
hoods only).
8
Remove the
Aluminum Filter
from the hood by
pulling the tab
down and lifting
filter out.
(4)
9
Remove 8 Screws holding Bottom Pan to hood.
Disconnect Light Harness.
10
Remove parts bag included with the hood. (Parts bag is
taped to inside of bottom pan.)
SCREWS
DAMPER /
DUCT
CONNECTOR
Remove 2 Screws holding Damper / Duct Connector to
11
hood. Remove damper/duct connector from inside the hood.
* FIND INSIDE
OF HOOD
(1) 3¼" X 10"
(1) 7" ROUND
DUCT
CONNECTOR*
CONNECTOR
** FIND PARTS BAG
INSIDE OF BOTTOM PANEL.
(1)
PULL
ALUMINUM
(2)
DOWN
LIFT
OUT
(4)
Remove 7" Round Duct Plate from top/back of hood.
12
FOR NON-DUCTED INSTALLATIONS - Skip to
"INSTALL THE HOOD" .
BAFFLE
FILTER
DUCTED INSTALLATION ONLY:
13
Remove Baffle from Slot above air box.
BAFFLE
14
DUCTED INSTALLATION ONLY:
Rotate Baffle and insert long side into Slot above air
box. Baffle is inserted properly when you feel a positive
stop.
CBX1 SERIES
7" ROUND
DUCT
PLATE
SLOT
SLOT
Page 4
Publicidad
Tabla de contenido
