Cleaning & Maintenance; Error Codes; Disposal Information - Renfert SILENT TS2 Guia De Inicio Rapido

Ocultar thumbs Ver también para SILENT TS2:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 19
Programming
For the extractor programming instructions, please see enclosed Quick Reference Card and full set of
operating instructions on the internet.
EN
Cleaning / Maintenance
Wipe the product down with a slightly damp cloth.
Replacing the Dust Bag
It is essential to change the dust bag when indicated as follows
on the product display:
The set dust bag fill level has been reached:
♦ The dust drawer symbol blinks.
♦ An audible signal will be emitted 3 x.
♦ The display blinks "Cod01".
Emptying the dust drawer:
⇒ Switch the extractor off.
⇒ Pull the front panel forward and off (5, Fig.1).
⇒ Pull the dust drawer (7) out towards the front.
⇒ Remove the protective film from the glue flap and use it to cover
the dust bag opening!
⇒ Dispose of the dust bag properly.
⇒ Insert a new dust bag into the dust drawer. Ensure that the
new dust bag is properly aligned in the guide grooves (21) and
the glue flap faces upwards.
Use only original Renfert dust bags (see spare parts list).
⇒ Inspect the dust drawer seal for damage and replace it, as
required (24).
⇒ Insert the dust drawer, making sure it is straight, and push it
in as far as it will go. Make sure that the dust drawer is seated
correctly on the guide (23).
⇒ Install the front panel on the bottom hooks then push it into the
upper lock bolts, pressing firmly until it locks in place.
Errorcodes
If an error code is displayed during operation or in diagnostic mode, please consult the full set of operat-
ing instructions on the internet for the relevant information on the required course of action.
Spare parts
You can find components subject to wear and the spare parts on the spare part list in the internet at
www.renfert.com.
The components excluded from the warranty (such as consumables or parts subject to wear and tear)
are marked on the spare part list.

Disposal Information

Within the European Union, units with this symbol should not therefore be disposed of in unsort-
ed domestic waste.
Please contact your local authorities for more information on proper disposal.
- 4 -
22
7
23
21
24
Subject to change

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

2930 00502930 1050Silent ts 2

Tabla de contenido