Authorized Persons; Product Description - Renfert SILENT TS2 Guia De Inicio Rapido

Authorized Persons

Operation and maintenance of the device may only be performed by qualified personnel.
EN

Product Description

See Fig. 1 (on inside cover)
3 On / off switch
5
Front panel/ Dust drawer
7 Dust drawer
8 Mains cable
9
Device coupler socket (A, B)
10 Device protection switch
15 Pinch valve with extractor connection fitting (rotatable)
16 Suction pipe
17 Connection set
18 Suction hose
The other units are covered in the full set of operating instructions available on the internet.
Scope of Delivery
1 Silent TS2
1 Operating instructions
1 Quick reference card
1 Dust bag (ready for us in the dust drawer)
1 Compressed air tube (sealed)
2 Pinch valves with suction port
1 Connection set
2 Shockproof plug (only for 2930-0050)
1 4 m Suction Hose
4 PVC end bushings
Setting Up
Unpacking
⇒ Check the delivery for completeness (refer to the "Scope of Delivery" section).
Setup
If the device is to be installed in a cabinet, an opening for the exhaust air with the following dimensions
must be provided, in addition to the openings for the suction hoses:
• Circular opening:
• Rectangular opening:
Installing the Pinch Valves
⇒ Push the suction pipe (16) onto the suction support on the
extractor and hang the holder (20) onto the holder screws.
⇒ Connect the compressed air tubes to the pinch valves:
- Push the compressed air tube onto the pipe connection
in the pinch valve as far as it will go. There will be a slight
resistance to overcome when attaching.
Min. 120 mm diameters.
Min. 170 x 65 mm.
- 2 -
15
18
20
16