Tools Required - Kohler VINTAGE K-2800 Instrucciones De Instalación

TOOLS REQUIRED

S
Level
S
Drill with assorted bits
S
Socket wrench with 8" (20.3cm)
extension and assorted sockets
INSTALLATION
S
Rough-in the supplies and drain
piping and trap.
NOTE: The supply stop handles
cannot extend more than 7-1/4"
(18.4cm) from the finished wall when
in the open position.
S
Install sufficient backing behind
the finished wall to provide a
secure material for the anchoring
devices.
S
Install hanger to wall according
to roughing-in dimensions.
S
Mark the centerline on the floor.
S
Position the pedestal on the floor
centerline so the mounting hole
is approximately 9" (22.9cm)
from the finished wall.
S
Position the lavatory on the
hanger and pedestal ensuring
the lug on the lavatory sets
behind the lug on the pedestal.
S
Move the pedestal as required
to ensure proper fit in the
desired location.
NOTE: The lavatory
supported by the hanger and
pedestal.
S
Check the lavatory placement.
S
Mark the center of each
anchoring hole through the
lavatory onto the wall.
S
Place the pedestal mounting bar
across lugs in base of pedestal
and mark the center hole onto
the floor.
S
Carefully remove the lavatory
from the pedestal. Then move
the pedestal from the area.
A
1010423-2-
S
Tape measure
S
Framing square
Lag
Bolts
Finished
Wall
Anchoring
must be
Hole
Pedestal
Mark Floor
Here
2
Kohler Co., Kohler, WI U.S.A.
Hanger
Lavatory
Lug
Pedestal
Lug
Pedestal
Base
Pedestal
Mounting
Bar