Check Before Treatment - NSK Ti MAX Z Serie Manual De Operación

3. Check before treatment

Follow the check below, before use. If any abnormalities are found, stop using the handpiece immediately and contact the authorized NSK dealer.
1 ) Check that the Head Cap is firmly tightened.
2) Insert the Bur. ( Do not exceed maximum rotation speed for any item. )
3 ) Check that there is no abnormal rotation, vibration, noise and overheating.
4 ) If there are no immediate apparent abnormalities, continue to rotate the handpiece for about 1 minute. Then check that there is no abnormal
heating on the outer surface.
5 ) Operate it if there are not abnormalities above.
4. Mounting/ Removing the Bur
4-1 Mounting the Bur
4-1-1 Mounting the Bur ( CA Bur ) to Z10,Z10L,Z15,Z15L,Z24L,Z25,Z25L
1 ) Insert and llightly turn the bur until it engages with the latch mechanism. ( Fig. 1 )
2 ) Push the bur further inwards until it clicks into place.
6
D-shape
Fig. 1