Marshall STUDIO CLASSIC SC20H Manual Del Usuario página 3

ENGLISH
Warning: before going any further, make
sure that your amp is compatible with your
mains electricity supply. If you have any
doubt, please seek help from a qualified
technician – your Marshall dealer can help
you with this.
MAINS INPUT & FUSE
The specific mains input voltage rating
that your amp has been manufactured for
is indicated on the rear panel of the amp.
Your amp is provided with a detachable
mains (power) lead, which should be
connected to the mains input socket on the
rear panel of the amp. The correct value
and type of mains fuse is specified on the
rear panel of the amp.
Never attempt to bypass the fuse or fit one
of the incorrect value or type.
1.0
WARNING! SAFETY INSTRUCTIONS
PLEASE READ THIS MANUAL CAREFULLY BEFORE PLUGGING IN. FOLLOW ALL INSTRUCTIONS AND HEED ALL WARNINGS.
IMPORTANT SET UP INFORMATION
1. When using your amp with one or
more speaker cabinets, make sure
that they are connected to the correct
loudspeaker jack sockets.
Warning: failure to do the above may
damage your amp. When connecting
a speaker cabinet make sure that you
use a proper speaker cable. Never use a
screened (shielded) guitar cable for this
purpose.
2. Ensure that the power switch is set to
the off position and the standby switch
is set to standby.
3. Connect the supplied mains (power)
lead into the mains input on the rear
panel first and then into an electricity
outlet.
4. Ensure that any master, volume and/
or output level controls on the front
panel are set to zero.
5. Plug your guitar into one of the input
jack sockets on the front panel.
6. Turn the front panel power switch on
and wait a couple of minutes.
7. Select between 20W / 5W using the
standby switch.
8. Turn the volume up to your preferred
level and you're ready to play.
TRANSPORTING YOUR EQUIPMENT
Please ensure that your amp is switched
off, unplugged from the mains electricity
supply and all removable cables have been
disconnected from your equipment before
attempting to move it.